MCON Magic Coat DP

Product Description

MAGIC COAT DP is a fifiber reinforced elastomeric liquid applied water proofifing membrane. It is formulated with select elastomeric and resilient acrylic polymers and reinforcing polyester fifibers. Upon curing, it forms a thick, seamless, durable membrane thus offering ultimate waterproofifing. MAGIC COAT DP is elastomeric in nature and has good resistance to weather and sunlight. MAGIC COAT DP has excellent flflexibility and bonding with concrete designed for protection of all types of thermal insulation

Description

Features & Benefits
Elastomeric – On that accommodate cracks up to 2 mm with an
elasticity of 100-150%. All surfaces to be waterproofed should be sound, clean and dry and free
of any laitance, grease and oil, dirt and other loose materials. Algae and fungi must be removed physically. After treatment leave for 2-3 hrs and then wash down thoroughly with clean water and allow to dry
completely. MAGIC COAT DP should be applied by brush, trowel, airless spray in two coats maintaining the spreading rate to achieve the desired DFT of 1 mm. The material consumption shall be approximately 0.2 to 0.3 kg / m2 per 2 coats. In critical applications where film thickness is paramount and desired than
the stated one then two coats should be applied with quantities per coat gauged to give the specified final film thickness. On a vertical surface if high film build up is desirable then additional coat
may be required. Low water permeability – excellent resistance to ingress of water. Adhesion – excellent adhesion to concrete and masonry surfaces. No curing required. Elongation at Break – The elongation of the unreinforced system after 7 days cure at 68°F (20°C) when tested against BS 2782 or similar test method is typically 90%.

Method of Application
All surfaces to be waterproofed should be sound, clean and dry and free of any laitance, grease and oil, dirt and other loose materials. Algae and fungi must be removed physically. After treatment leave for 2-3 hrs and then wash down thoroughly with clean water and allow to dry completely. MAGIC COAT DP should be applied by brush, trowel, airless spray in two coats maintaining the spreading rate to achieve the desired DFT of 1 mm.
The material consumption shall be approximately 0.2 to 0.3 kg / m2 per 2 coats. In critical applications where film thickness is paramount and desired than the stated one then two coats should be applied with quantities per coat gauged to give the specified final film thickness. On a vertical surface if high film build up is desirable then additional coat may be required.