MCON DECO RELEASE is a dry blend of hydrophobic powders, proprietary ingredients with colouring pigments. MCON DECO RELEASE is designed for use in the concrete imprinting process to allow the clean release of texturing tools from the wet concrete surface. MCON DECO RELEASE adds colour variations and highlights to the textured surface, providing an attractive two-colour antiqued look that very closely resembles natural materials such as cobblestone, brick, tile and slate. The MCON DECO RELEASE release powder is the highlighter not the primary colourant in the concrete; colouring of the concrete achieved by using colour hardeners. Colour hardener provides a greater colour selection including light hues and pastel, the resulting finish has a harder more wear resistant surface and the material cost is low.
1. It is highly recommended to develop and follow a routine maintenance schedule for all colored concrete so that it will maintain a top quality appearance.
2. Every 24 to 60 months, coloured concrete installations should be inspected, cleaned and resealed as required by volume and intensity of traffic.
3. The need will depend on a number of factors including traffic conditions, geographical location and weather.
1. It is helpful to also coat the stamps with release powder before placing on wet concrete for the first time.
2. Never drag anything on the surface or trowel over release powder. Discoloration will occur.
3. If the stamps have been recently washed, they must be fully dry before starting to stamp. Any moisture still left on the mats will decrease the release powder efficiency resulting on concrete adhering to the stamp.
4. Before pressure washing the concrete, broom off the release powder or pick up with a wet vac.
5. The release powder may also be removed without pressure washing by using a liquid soap and brooms to remove excess.
6. If after pressure washing and cleaning there is still too much release on the surface a very mild water/ muriatic acid solution may be used to complete the removal. Use this process with caution.
If you’re switching to a different release colour, be sure to clean off the stamp mats between uses. For example, if you use a dark brown release on one job and then a few days later use the same stamps on another job with a light charcoal release, the dark brown could contaminate the charcoal colour if you don’t thoroughly clean the mats first. Even if you use the same release colour from day to day, it’s important to clean the mats if you see a layer of paste build-up that could affect the imprint quality.
The final colour of the concrete is affected by many factors. It may be a function of the basic concrete mix ingredients (fine aggregate, coarse aggregate, water and cement), the weather, finishing techniques, experience of the applicators, and colouring method used (colour hardener or acid stain).
1. Allows a clean bond break between fresh concrete and stamping mats.
2. Adds colour variation-antiquing affect for stamped surfaces.
3. Easy removal process allows for controlled removal to achieve desired shading effect.
1. After concrete is coloured with MCON DECO HARD FLOOR and it reaches the proper set for imprinting, hand broadcast the Mcon Deco Release powder evenly over the surface to be stamped.
2. Care should be taken not to trowel the release powder into the wet concrete; this will cause a permanent discolorations. After release powder has been applied, follow your regular procedure for stamping concrete.
24 months in original packing if stored at room temperature i.e.25o C.
1. Garden Pathways
2. Shopping Malls
3. Parking Areas
4. Restaurants
MCON Deco Release is a release powder used in decorative flooring to facilitate clean separation between fresh concrete and stamping mats. It also adds colour variation for an antiquing effect on stamped surfaces.
Coverage: 750 – 800 Sq. Ft. / Pack
Packing: 9.1 kgs.
No Features & Benefits content added yet.
08976907887 
sales@mconrasayan.com 
