MCON HARD FLOOR (METALLIC) is a ready to use, factory controlled, dry shake, metallic material containing aggregates & special additives which offers resistance to abrasion and wearing of concrete. MCON HARD FLOOR (METALLIC) makes a concrete floor with non-dusty, non-slip, dense and tough characteristics.
1. Good wear resistance rating.
2. Corrosion resistant – Does not contain any ferrous aggregate, so no rusting & erosion of floor, contains metal alloys to give strength and avoid corrosion.
3. Ease of application – pre-mixed powder, easy to dry shake & trowel.
4. Increased resistance to oils and grease.
1. Warehouses
2. Factory
3. Shopping Malls, Parking Areas
4. Vehicle maintenance floors.
5. Loading Docks.
6. Main, High Traffic Aisle ways / Gangways.
7. Breweries & Bottling plants
8. Joint shoulders reinforcement
1. The base concrete should have a minimum cement content of 300 kg/m³ with low slump of – 40-60 mm.
2. Improves the quality of concrete mix and enables low w/c ratio to be kept By using MCON SRP 50, work ability of base concrete can be improved with a low w/c ratio.
1. The base concrete must be laid in accordance with good concrete practice either in bays or long strips.
2. Particular care must be taken at the corners and edges of the bays to obtain good compaction and to maintain level for subsequent trowel operations.
3. If too much of free water is seen on the surface, water content in subsequent concrete must be reduced to obviate the presence of free water.
4. The time of the application is very important in order to derive full benefits of MCON HARD FLOOR (METALLIC).
5. If MCON HARD FLOOR (METALLIC) is applied too early, it will absorb water, hard wearing aggregate may sink to the bottom.
6. If application of MCON HARD FLOOR (METALLIC) is delayed, no moisture from the concrete surface will be available to hydrate MCON HARD FLOOR (METALLIC), resulting in poor pitted surface
7. (When tested with Thumb, it leaves an impression but concrete does not stick to the Thumb).
8. (Separate Application guide is available on request). The optimum application rate is 5 kg/m of MCON HARD FLOOR (METALLIC) Powder.
1. Store away from direct sunlight. 12 months from date
of manufacture.
1. Wear hand gloves, safety shoes and safety goggles while using and handling the product.
2. In case eyes or mouth are affected wash with plenty of clean water and seek medical treatment immediately
1. 3 to 5 kgs. Per m – Medium Duty
2. 5 to 7 kgs. Per m – Heavy Duty
25 Kgs Bag
No Features & Benefits content added yet.
08976907887 
